Installation Guide

Follow These Simple Steps (video included at bottom for visual demonstration).

1. Unpack your new Hitch Switch cover and/or designs

2. Dis-assemble the black pin and silver cotter pin from your Hitch Switch cover (if assembled)

3. Insert the square tube of your Hitch Switch cover into your car's receiver tube. Be sure that the opening on top of the Hitch Switch is facing upward (this is where you slide your image into).

4. Once inserted, make sure that the holes on your vehicle receiver line up with the holes of your Hitch Switch adapter tube.

5. Slide the black hitch pin through the holes one side of your vehicle's receiver tube & Hitch Switch adapter, all the way to the other side.

6. Once the black hitch pin is all the way through, push the silver cotter pin through the small hole at the end of the black hitch pin.

7. With your Hitch Switch now installed, slide the design you want to display down through the slot/opening at the top of your Hitch Switch cover. Now you are all set, and ready to roll. Welcome to the Fleet!